Network to Serial Adapter for eMotimo Spectrum ST4 and ST4.3

This device takes an RJ45 Network Cable. Once configured, this Network Adapter has an assigned IP address that is addressable from Skaarhoj PTZ controllers. This box then connects to the Spectrum ST4's i/o port to allow the eMotimo Spectrum ST4 to communicate over a wired network to the Skaarhoj controller.

This device includes a 5V DC power source for US wall plugs. Watch out - don't use anything but this adapter as higher voltages will destroy it.

This device is initially configured be DHCP (dynamic ip address) but should be configured to a static ip address on your network.  

Instructions for configuration for Skaarhoj can be found here. 

Update  -  We are also using this network adapter to chat with other network devices like Unreal Engine as well as Bitfocus Companion + Streamdecks. 

Note for Beltless Dana Dolly Users:
Do not purchase this adapter if you use a beltless Dana Dolly setup. The DDV3 track sensor uses the same I/O port on the ST4/ST4.3 as the Network Adapter, which means they cannot be connected or used at the same time.